ConcoursMustang Forums
Marketplace => Wanted Ads => Topic started by: 21.04 on December 01, 2022, 10:34:52 PM
-
I'm hunting for four coarse thread bolts that secure the shift boot to the top of the box on the drive tunnel. Attached photos of what I believe I need. My car is a 7/1/66 projected production SJ built HP Conv. Bolts must be rust free unrestored originals.
-
I'm hunting for four coarse thread bolts that secure the shift boot to the top of the box on the drive tunnel. Attached photos of what I believe I need. My car is a 7/1/66 projected production SJ built HP Conv. Bolts must be rust free unrestored originals.
Your picture is of a sheet metal screw . I believe the correct fastener instead is a different thread bolt. Sorry I don't have a picture. I bet Jim has the specs.
-
I'm hunting for four coarse thread bolts that secure the shift boot to the top of the box on the drive tunnel. Attached photos of what I believe I need. My car is a 7/1/66 projected production SJ built HP Conv. Bolts must be rust free unrestored originals.
Your picture is of a sheet metal screw . I believe the correct fastener instead is a different thread bolt. Sorry I don't have a picture. I bet Jim has the specs.
I'm as confused as Bob as to what you are showing.
Let's start here:
What transmission?
You will NOT find "rust free unrestored originals" after 56 years.
Jim
-
For manual trans:
50527-S2 2 FF049 1/4-20X5/8PAN 1/2,XREC SCREW,PAN,PHLPS 4 TRANS,MT,SHIFT BOOT COVER,3 SP&4 SP
Now you are going to have to re-thread or use an insert on the threads in the car.
Alternatively, just braze the hole. MIGed holes get far too hard.
NPD pic of the screws, 7138-1K, for reference or purchase.
-
Forgot to add transmission type is manual so the screws you've identified at NPD are what I'm hunting for. They are for a t-bred so I'll need OEM screws.