ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1970 Mustang => Topic started by: BHStang on November 27, 2023, 03:55:20 PM
-
What is the correct width of the center strip at the back of the hood? This is for a 351 Shaker June 10, 1970 build at DAP. I believe it should tapper to 14.5" at the front edge but I have seen various sizes claimed for the rear. 15.25"? the stencil I have puts it at 16.25"
-
Based on the one angle I can see of a 428 car in the unrestored thread the stripe extends out about 1/2? wider than the shaker trim ring. So if the trim ring is 14 3/4? that would put the stripe at 15-3/4? with some slight tapper wider going back. This leads me to believe the stencil I have at 16? is actually probably correct.
-
Correction my stencil is 16-0?