ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1964 1/2 - 1965 => Topic started by: C5ZZKGT on May 20, 2011, 06:08:42 PM

Title: '65 K code lower clutch spring
Post by: C5ZZKGT on May 20, 2011, 06:08:42 PM

Mine rubs aganst the exhaust manifold and makes noise whenever I push in or let out the clutch, it seems to be installed right/the way I remember it being......any ideas or is it just the fact of the Hipo manifolds?

Title: Re: '65 K code lower clutch spring
Post by: CharlesTurner on May 23, 2011, 10:36:29 AM

Probably going to have to provide a pic.  Does your bell housing fork lever have a point on the exposed end or is it flat?

Title: Re: '65 K code lower clutch spring
Post by: MWM on May 23, 2011, 06:24:00 PM

I had the same issue.  My solution was to drill a small hole in the under engine cross brace and move it over about an inch.  Good Luck!