ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: orgnl70 on May 23, 2024, 10:54:41 AM

Title: 67 Fastback doors
Post by: orgnl70 on May 23, 2024, 10:54:41 AM

67 Fastback with factory Convenience group. At some point the doors were replaced with non convenience group doors.  No cutout for courtesy light and no pass thru on A pillar for wiring to the door.. The cutout is no problem. What is the location of the pass thru? Was there any shielding or protective cover from the pillar to the door? Any photos would be of great help.
Thanks

Title: Re: 67 Fastback doors
Post by: J_Speegle on May 24, 2024, 05:59:07 PM

Hope this helps. Happens to be a San Jose built car not sure where your car was built or when. May make a difference

(https://www.concoursmustang.com/forum/gallery/20/6-240524165744-203462003.jpeg)

Title: Re: 67 Fastback doors
Post by: 67gta289 on May 24, 2024, 08:18:43 PM

If my memory is correct there are locating dimples in the sheet metal that you can use for reference

Title: Re: 67 Fastback doors
Post by: gtamustang on May 25, 2024, 06:48:53 PM

Quote from: 67gta289 on May 24, 2024, 08:18:43 PM

If my memory is correct there are locating dimples in the sheet metal that you can use for reference

Your memory is still going strong; There are locating dimples on the door and on the door pillar.

Regards,
gtamustang