ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1966 Mustang => Topic started by: redmach69 on August 14, 2024, 10:12:26 AM
-
Hi guys I didn't know where to ask this so if it's in the wrong place I apologize. I have a chance to buy a 1 owner 1966 gt, But the car was damaged in the 70's and the forward drivers fender apron was sectioned so the exposed vin is gone, it is even worse in that it was sectioned with junkyard parts and the exposed vin is different from the door tag and title. I do not doubt the cars originality but my question is, is it acceptable to notch the passenger fender to expose the hidden vin, or the rear of the drivers side if it has one there. It is obvious the front has been sectioned (1970's stick welding). Or is a state replacement vin and reconstructed title, with the resulting destruction of value the only option.
-
pics would help to decide.
-
Don't really have any pics of the parts in question, the car has been in a building with no electricity for over 25 years. I will say this the door tag is complete with proper rivets, and matches the title, the vin starts 6T07A the vin on the replaced fender apron is 6F07T so obvious different plant and engine.
-
Don't really have any pics of the parts in question, the car has been in a building with no electricity for over 25 years. I will say this the door tag is complete with proper rivets, and matches the title, the vin starts 6T07A the vin on the replaced fender apron is 6F07T so obvious different plant and engine.
At the very least I would have to make the incorrect VIN on the replacement apron disappear. Touchy deal.
-
Hi guys I didn't know where to ask this so if it's in the wrong place I apologize. I have a chance to buy a 1 owner 1966 gt, But the car was damaged in the 70's and the forward drivers fender apron was sectioned so the exposed vin is gone, it is even worse in that it was sectioned with junkyard parts and the exposed vin is different from the door tag and title. I do not doubt the cars originality but my question is, is it acceptable to notch the passenger fender to expose the hidden vin, or the rear of the drivers side if it has one there. It is obvious the front has been sectioned (1970's stick welding). Or is a state replacement vin and reconstructed title, with the resulting destruction of value the only option.
No not in a concours setting (with my judges cap on). It would look extremely unusual and be the source of endless negative speculation. I would think that a blank apron with a picture of the correct hidden vin to show as proof would be the best course of action but that is just me. This car would have to be special or a extremely good price to justify all of the hassle IMO.
-
There are actually three locations for the stamped VIN on the fender aprons - the "exposed" one on the left side, a second stamping about 8 inches further back on the fender apron near the LH hood hinge, normally covered by the fender, and a third on the right hand fender apron near the RH hood hinge, also covered by the fender.
Jim
-
Thanks Bob for the reply, thanks jwc66k I understand where the hidden vins should be, hence my question about notching the fender to expose them.
-
Thanks Bob for the reply, thanks jwc66k I understand where the hidden vins should be, hence my question about notching the fender to expose them.
The name is Jim, and I make it a point to sign my posts.
DO NOT NOTCH THE FENDERS. Remove the 4 fender bolts near the hood hinges, don't forget the one hidden at the rear of the fender visible when the car doors are open, and then lift the edge of fender. You should be able to see the VINs.
Jim
-
Thanks Jim, that's good info, I had read I would need to remove them.
-
Thanks Jim, that's good info, I had read I would need to remove them.
Only for inspection by state personnel or those (at a later date) looking to possible purchase said car. Agree that notching a fender is not an option IMHO. The same inspecting and looking for clues will likely take place to determine if the car is an original GT if the car is put up for sale also. Hope your state is not one that will require a "visible" VIN stamping or your looking at a state issued VIN, extra tags and possible stampings or over stampings. No the door tag does not count - but there is always one DMV worker that doesn't follow the rules out there.
-
Thanks everyone for the good info, I knew I could count on Concours Mustang.