ConcoursMustang Forums

Marketplace => Wanted Ads => Topic started by: Angela on February 18, 2025, 08:13:24 AM

Title: Mach1 molding Clip
Post by: Angela on February 18, 2025, 08:13:24 AM

I would greatly appreciate help locating six (6) original clips used to attach the 1970 Mach1 molding panel to the door. The clips were only used to attach the molding to the doors (rocker moldings held using other methods).

I have enough original clips to attach one molding, but not both doors.

Please contact me if you have any of these clips or could point me in that direction. Thank you!

Title: Re: Mach1 molding Clip
Post by: truetriplex on February 18, 2025, 11:17:06 AM

Can you post a picture next to a ruler please

Title: Re: Mach1 molding Clip
Post by: Angela on February 21, 2025, 09:01:26 AM

The original clips are approximately 0.8" x 0.6", with a slotted stud.

Title: Re: Mach1 molding Clip
Post by: truetriplex on February 21, 2025, 09:25:16 AM

Dave at Restoration Specialties should have these.  I have gone with him for over 2 decades, and he's the man. His catalog has pictures of his clips and they are to scale to the clip.   

https://www.restorationspecialties.com/

Title: Re: Mach1 molding Clip
Post by: Angela on February 23, 2025, 06:54:44 AM

Thank you "Truetriplex"! I sent a message to restoration specialties on the 21st and am hopeful that he will respond.

Title: Re: Mach1 molding Clip
Post by: truetriplex on February 24, 2025, 09:24:28 AM

did you look at the on-line catalog? it has pictures of the clips