ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: Andrew@MagMustangs on September 26, 2011, 01:43:49 PM

Title: Wiring for Fuel Sending Unit?
Post by: Andrew@MagMustangs on September 26, 2011, 01:43:49 PM

In 67-68 was there a difference in the Trunk Hole Location where the wiring feeds through the Trunk Floor for Single or Dual Exhaust Cars? Middle-Front of Trunk vs. RH Side Hole? Or did all 67-68s go through the Rh Side? Thanks, Andrew

Title: Re: Wiring for Fuel Sending Unit?
Post by: CharlesTurner on September 26, 2011, 04:24:00 PM

Quote from: MagMustangs on September 26, 2011, 01:43:49 PM

In 67-68 was there a difference in the Trunk Hole Location where the wiring feeds through the Trunk Floor for Single or Dual Exhaust Cars? Middle-Front of Trunk vs. RH Side Hole? Or did all 67-68s go through the Rh Side? Thanks, Andrew

Only seen them go through the passenger side trunk floor.  Only cars I have seen that don't follow that pattern were easily recognizable as having sheet metal replacement in the rear.

Title: Re: Wiring for Fuel Sending Unit?
Post by: gtamustang on September 26, 2011, 04:55:39 PM

As Charles has stated, all 67-68 fuel sending pigtails went through the rh trunk floor pan in the same location (same size hole in same location).

Regards,
Pete Morgan

Title: Re: Wiring for Fuel Sending Unit?
Post by: Andrew@MagMustangs on September 26, 2011, 05:27:41 PM

Thanks!!! It seems 69-70 had this difference between Single and Dual Exhaust Cars, and I wasn't sure if 67-68 had that same difference. Thanks Charles and Pete.