ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1970 Mustang => Topic started by: joe747 on January 15, 2012, 05:18:44 PM

Title: 70 engine feed harnass
Post by: joe747 on January 15, 2012, 05:18:44 PM

want to install the engine feed harnass (one that comes from the coil .were there some kind of clips that it attaches to

Title: Re: engine feed harnass
Post by: jwc66k on January 15, 2012, 05:40:33 PM

What year, what engine?
Jim
And get a set of Mustang Assembly Manuals for your car's years.

Title: Re: engine feed harnass
Post by: joe747 on January 15, 2012, 05:46:37 PM

1970 mustang 351 cleveland engine

Title: Re: 70 engine feed harnass
Post by: Carl on January 15, 2012, 09:40:44 PM

Unfortunately, there's no engine assembly manual for '70s, but good news, the clips are shown in the electrical assemmbly manual.  As books go, its probably the most worthwhile piece for restoring a '70.
There's 2 J clips that hold the wiring in place, the first on the farthest back and highest valve cover bolt driver's side valve cover, the second being on the second in from the back valve cover bolt (top row) on the passenger side valve cover.  Clips are Ford Number 356640-S100, AMK had a VERY close substitute, that just needed a bit of bending to work.  Two more of the same clips are used for the solenoid wire if you have AC, they go on the second and third in from the back valve cover bolts on the drivers side valve cover.

  Carl