ConcoursMustang Forums
Restoring - General discussions that span across many different groups of years and models => Misc Items => Topic started by: sparky65 on February 03, 2012, 04:11:17 PM
-
Is there any way to refinish wiper arms? It looks like part is stainless but the other part that goes on the shaft appears to be some pot metal. I was going to try to sand and polish them until I realized they are supposed to be satin finish. Not sure how to recreate that. :-\
-
Might be able to play some tricks with buffing and then hitting real light in the blast cabinet with glass bead. Probably a combination that will work. Otherwise, paint is another option.
-
Or replace them with a better set
-
Motorcraft argent paint does a pretty good job.
-
Or replace them with a better set
Let me guess, something you just go to the scrapyard and pickup whenever you need? ;-)
-
Motorcraft argent paint does a pretty good job.
Might try that. Apparently the pot metal was chromed.
-
Let me guess, something you just go to the scrapyard and pickup whenever you need? ;-)
Don't even go there, it will just leaqve you wanting ;)
-
I restored a set of satin finish wiper arms for a buddy's 66 with the following process that turned out pretty nice:
1. Cut - use 3M Scotch Brite EXL deburring wheel to remove haze, tarnish, and restore surface from areas on wipers arms that are stainless. Don't hit the pot metal part with this. I think I used an 8S FIN wheel, but may have used one grade coarser.
2. Buff - green and/or black rouge on hard cotton buff wheel. Just enough to "even out" the stainless surfaces cut in the previous step.
3. Polish - Simichrome on soft cotton buff wheel. Just enough to give the "color" you are looking for. Include the pot metal area in this step.
Of course, I didn't have an nice original set of wiper arms to compare the results from this process against, so YMMV depending on your criteria. But the Scotch Brite wheels are made for finishing stainless steel in particular and I thought this was a better alternative than painting. If you read the product literature on the 3M unitized (and also convolute) wheels, you can see what is recommended for jobs like deburring turbine blades to putting satin finish on stainless steel silverware...