ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Shelby => Topic started by: ceswert on September 04, 2012, 06:49:54 PM
-
I am having Jim Cowles modify a 67 Mustang valance to match an early 67 Shelby. He has looked at a few early cars and has noticed a screw at the top of each bezel. He is not entirely sure how early this appears and when it ends. My #89 car will be fitted. Any thoughts on whether this screw is correct or not for mine? He will be sending me a picture of an early car's valance and bezel.
-
I've got the modified 65-66 Mustang GT trim on 67 Shelby's during the early #50 cars at least and continuing far past your cars assembly date. Of course the early production practices can produce some odd results I think your safe in using those on your car - though of course I will await additional confirmation from Bob :) when he sees the post
-
Thanks Jeff. I am still waiting for a couple of pictures from Jim C. I am showing the 67 and the Super Snake in the Orinda Car Show Sept. 22. It's from 10am-2pm. They are going to have a special area for Shelby cars. It's a good show with a variety of makes. Usually around 200 entrants are there.
-
I've got the modified 65-66 Mustang GT trim on 67 Shelby's during the early #50 cars at least and continuing far past your cars assembly date. Of course the early production practices can produce some odd results I think your safe in using those on your car - though of course I will await additional confirmation from Bob :) when he sees the post
+1. to add to Jeffs post the top center screw is a rounded stove bolt type .
-
I will pass along. Thanks!