ConcoursMustang Forums

Restoring - General discussions that span across many different groups of years and models => Interior & Trunk => Topic started by: qman on February 04, 2010, 10:43:06 PM

Title: dash pad repair question
Post by: qman on February 04, 2010, 10:43:06 PM

On the underside of a 67 mustang dash pad, close to the base of the "A" pillar, are fasteners embedded in the foam.  On my car water must have found a way to get in there and the little fastener is no longer attached to the foam. Do you have any suggestions on reattaching this piece?   
Thanks, Quentin

Title: Re: dash pad repair question
Post by: Sunlitgold68 on February 04, 2010, 10:44:33 PM

I used gorilla glue, some on the bottom then set it in place, then put some all around the edges.