ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1969 Mustang => Topic started by: Brian Conway on September 28, 2013, 01:23:02 PM

Title: 69 Antenna
Post by: Brian Conway on September 28, 2013, 01:23:02 PM

     Is it possible to identify this antenna by the C9AA-18A927-A ink stamped on the down side of the bezel ? If so; assembly line, service department or after market ?  Thanks,  Brian

Title: Re: 69 Antenna
Post by: PerkinsRestoration on September 28, 2013, 08:23:25 PM

No, the bezel fits other applications also. Is it correct for Mustang, yes. Your antenna is also correct as it has round mast and teardrop black insulator.

Title: Re: 69 Antenna
Post by: Brian Conway on September 28, 2013, 10:02:25 PM

     Thanks for the reply and information.  Brian

Title: Re: 69 Antenna
Post by: specialed on September 29, 2013, 06:53:41 PM

Brian the best way to check is looking under the cast base for fomoco 7-292 for 69-70 assembly line antenna & c9za # on bottom of rubber mount as cougar is c9wa. Many antennas look the same but the cast id # & rubber molded in # have to be correct for antenna to be mounted concours correct.

Title: Re: 69 Antenna
Post by: Brian Conway on September 30, 2013, 11:45:00 AM

     Thanks for the tip.  It seems that Ford took some extraordinary steps to insure that the antenna would be securely attached to the car.  I am going to leave well enough alone and not try to get a peek at the down side of either part.  I think I understand the " mounted concourse correct " portion of your statement.   Brian