ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1964 1/2 - 1965 => Topic started by: DM_1964 on March 28, 2014, 11:03:12 PM
-
Seeing that the mufflers weren't stamped with part numbers, I'm curious if the hangers and clamps were stamped with FoMoCo markings or where they plain like the mufflers.
From what I understand the only items that had a part number was the Y pipe and the tail pipe (referring to a V8 Single system exhaust)
-
Haven't found any markings on single exhaust hangers, but most I see are crusty-rusty, so hard to say for sure.
-
The tailpipe is stamped with the part # for the Muffler and tailpipe . Remember they are one piece units. The Y pipe is #ed also. Not sure on the intermediate pipe. Also there will be no resonator.
-
Haven't found any markings on single exhaust hangers, but most I see are crusty-rusty, so hard to say for sure.
Do you clean up the existing and reuse or are you replacing with repros? if so, where from?
The tailpipe is stamped with the part # for the Muffler and tailpipe . Remember they are one piece units
Just to confirm, do you mean the muffler and tailpipe one piece?
-
Yes the muffler and tailpipe are a single welded assembly .