ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1969 Mustang => Topic started by: 69GTconvert on June 18, 2014, 06:01:02 PM
-
I am looking to add the original intake back on my 69 Mustang but I'm not sure if I need a Distributor Vacuum Control Valve and am confused about which intake vacuum port I would need. Some info about my Mustang that may help:
- Built April 8, 1969 in Dearborn
- 390 4 speed car
- DSO in New Jersey
- Power steering
- Disc brakes.
1. Would I need a Distributor Vacuum Control Valve installed in the thermostat housing?
2. Based on the options I listed above, which intake vacuum port would I need from the pictures below?
Thanks.
-
Look on the Mansfieldmustang site, he has color pictures of intakes with those parts in the PCV section.
-
Look on the Mansfieldmustang site, he has color pictures of intakes with those parts in the PCV section.
Here is a link to the page mentioned above: http://mansfieldmustang.com/EnginePCV.html
And the '69 390 intake setup, after 2-21-69 pic: http://mansfieldmustang.com/04-42.jpg
1. Would I need a Distributor Vacuum Control Valve installed in the thermostat housing?
"Need"? Not necessary for the car to operate normally. Its purpose was to change the timing (by porting vacuum) if the car reaches a hot / overheat condition.
If you have one to install, then go for it. If not, then you can put a plug in the thermostat housing port and install the control valve when you have the desire.
If you are talking about installing one for "correctness"... um, I don't have an answer for that one >.>
-
1. Would I need a Distributor Vacuum Control Valve installed in the thermostat housing?
Since this is the Concours site - of course you would/will since it would not be restored without it
Also referred to as a PVS Ported Vacuum Switch
2. Based on the options I listed above, which intake vacuum port would I need from the pictures below?
The vacuum tree that you posted would attache to the other larger vacuum block at the rear of the intake
Closest match I have is a Non AC, PB, PS manual trans NJ 69 From the 9T01S151xxx period
(http://www.concoursmustang.com/forum/gallery/2/6-180614210724.jpeg)
And a Dearborn examples (ignore the PO manual choke upgrade :)
(http://www.concoursmustang.com/forum/gallery/2/6-180614211244.jpeg)
Both cars still have the Autolite 4300' s so not allot of things have been done to these cars. Not restored by a long shot
In both it appears that there is a single hose attachment at the rear unlike the one you posted which has two hose connections
Hope this helps
-
That brass block was added after engine was painted & should never be painted & different types depended on options p/b tilt shaker a/c etc. but the 1 you have in picture is most common.
-
Thanks everyone for your feedback, pictures and links.
I contacted Mansfield Mustang about which intake vacuum port would be correct for my application. The picture posted on their site shows a brass block with a threaded hole on one side (maybe for the disc brakes) and two other vacuum ports like the picture of the brass block I posted. Mansfield told me a Mustang could have come with a brass block from the factory with additional ports and if some were not needed, they would be blocked off with a rubber plug. He told me they grabbed whatever was available at the time on the assembly line.
Most of the brass blocks I have seen for my Mustang come with the two vacuum ports and a larger threaded hole on one side. I have not seen a brass block with only one opening as were posted in Jeff's pictures, but I'm still looking.