ConcoursMustang Forums
Restoring - General discussions that span across many different groups of years and models => Drivetrain => Topic started by: Oz390 on September 17, 2014, 04:59:06 AM
-
Have a 4 bolt pulley, aligns to a water pump pattern, single sheave, ~5 7/8" OD.
Only markings are FoMoCo stamp and a "P", can find no reference to identify its original use... anyone know?
-
I believe that "P" is a manufacturers mark. Some pulleys were ink stamped.
-
Would need a measurement of offset too to have a chance at getting an I.D. of this pulley. Lay it face down and measure to top edge of pulley and maybe shoot us an image.
Richard
-
Front face is flat, center hub even with edge of sheave.
Cleaned it up a bit more and found a faint C6AE-9B447-E (I think), that is a smog pump pulley....???? 67 S code smog is one reference I found...