Author Topic: Measaurement needed.  (Read 787 times)

Offline hertz350

  • Full Member
  • ***
  • Posts: 162
Measaurement needed.
« on: April 09, 2021, 03:10:30 PM »
Looking for a measurement between the center of each tire on the front or back. In other words the measurement from front driver's side tire at the center to the center of the passenger side tire.
 
My friend is building ramps in his enclosed trailer and does not have his 69 Mach ! where he is. Any help is much appreciated!

Thank you.

Offline Brian Conway

  • Hero Member
  • *****
  • Posts: 1623
Re: Measaurement needed.
« Reply #1 on: April 09, 2021, 04:18:33 PM »
60"
5RO9A GT  4 Spd Built 5/29/65
9TO2R SCJ 4 Spd Built 9/19/68
Owner Driver Mechanic
San Diego, Ca.

Offline tobkob

  • Sr. Member
  • ****
  • Posts: 473
Re: Measaurement needed.
« Reply #2 on: April 09, 2021, 09:08:02 PM »
When I bought my enclosed trailer I installed 2 stacked 2x12's on each side so the bottom of the door cleared the fender at the escape door. I think they are 14' long and go start at the rear and I installed rubber stops at the front so it would always line up the door with the escape door. I attached the runners with carriage bolts and a steel plate underneath the floor. I think this is is what he is talking about. :)

TOB
1969 (04/07/69) GT350 owned since 1970. Only owner since Hertz.

Offline hertz350

  • Full Member
  • ***
  • Posts: 162
Re: Measaurement needed.
« Reply #3 on: April 10, 2021, 02:46:22 AM »
Thank you for the measurement. Yes, we are installing ramps as described above.