21
1970 Mustang / Re: Still looking for correct textured hood stripe paint for ?70 Mach 1
« Last post by fla2005 on May 16, 2024, 02:05:04 PM »I have used PPG Duracryl DDL 9381 textured black on 1970 Mach1 and Boss 302 applications.
Thank you for the information.
Did the 65 66 radiators all have the radiator opening off to the side or were some in the center?
Thank you for the confirmation.
In that case a very late build. I believe the last day of Mustang production at Dearborn was 8/12/1966.
When new they were more on the glossier side of semigloss spectrum however after a few heat cycles the paint typically dulls down .
"If anyone has FIRST hand experience with someone who can rebuild a 4300 and make it run properly there are a lot of us out here that would like to know"I had recommendations to send my last 4300 there too . It has been about 2 years ago . It looked great when I got it back however It didn't run or idle well like I expected given it was to be tested on a running engine prior to shipping. I was waiting on the carb to come back because it went on a sold car that the new owner knew that the carb was being rebuilt . I understand that the new owner had problems with it too. I don't know if the problem got solved .
Team,
Drew podjednic from air fuel spark recommended all state carbs in New York. www.allcarbs.com. Jarrod was great to deal with and my 70 Mach 1 4v D0OE-AD autolite came back looking amazing. They test them all before sending back. However I don't have my motor done to verify anything. Just my experience so far.
Dan in kansas