It really does take two people to handle this in a press.
However, this bushing is really rusted in there and I remember the easy, few tools method. This took about half an hour and a lot of that time was taken up taking pictures.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619222701.jpeg)
Pic 1:
Drill 4 holes in the rubber bushing. I started relatively small and worked my way up in three steps.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619222907.jpeg)
Pic 2:
Drill 4 more in between.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619222907.jpeg)
Pic 3:
Drill out the holes with a bigger bit.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619223131.jpeg)
Pic 4:
Drill sideways a little, hogging out the holes at an angle.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619223307.jpeg)
Pic 5:
By the time you hog out each of the holes at an angle the center bolt is ready to fall out.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619223350.jpeg)
Pic 6:
Yep.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619223433.jpeg)
Pic 7:
And then the rubber usually just falls out.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619223526.jpeg)
Pic 8:
Empty shell.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619223616.jpeg)
Pic 9:
Burr in a die grinder
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619223811.jpeg)
Pic 10:
Grind near where the spring returns back to itself.
![](http://www.concoursmustang.com/forum/gallery/12/4249-070619223947.jpeg)
Pic 11:
Since the shell is very thin at the grind line it takes little effort to carefully break the shell so it folds back into itself and drops out.